Happymodel BeecoreX FR Brushed F4 OSD 1S Flight Controller Built-in 5A Brushed 4IN1 ESC 5.8G 25-100mW VTX SPI Frsky RX for Brushed Tiny Whoop FPV Racing Drone
Introduction:
The BeecoreX is a ultimate flight controller for Brushed Tinywhoop , it include F4 FC, vtx , ESC, frsky receiver and betaflight OSD.
It makes very easy to build a brushed tinywhoop.
You only need to buy an FPV camera and brushed motors ,frame and propeller and then plug and play ,
No soldering require at all .
Specification:
Brand: Happymodel
Item Name: BeecoreX FR F4 1S Flight Controller
| Flight Controller
|
(Frsky SPI RX version) Betaflight Firmware Target: CrazybeeF4FR MCU: STM32F411CEU6 (100MHZ, 512K FLASH)Sensor: MPU-6000(SPI Connection) Board Size: 28.5 * 28.5mm Power Supply: 1S Battery Input (DC 2.9V-4.35V) Built-in 5A(each) Brushed 4IN1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX 25mw~100mw Switchable Built-in SPI Frsky receiver(compatible with Frsky_D/ Frsky_X/ S- FHSS/ Redpine protocol) Built-in 5V 1A BEC Built-in voltage detection |
Onboard Frsky SPI Receiver Version |
SPI BUS receiver Frsky Version Compatible with Frsky D8/D16 ( D8 is Recommend) , S-FHSS , Redpine ProtocolChannels: 8CH Failsafe Support No Ground Interference ( Transmitter and receiver 1 m from the ground): 100m~200m RSSI Compatible |
Onboard 5.8g VTX |
Output Power: 25mw~100mw Switchable (No Included Runcam Nano3 Camera)
|
Notes:
R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input.
IR1(IRX1) Pad is used for SBUS signal input (Already inverted).
R1 and IR1 Cannot be used simultaneously.
Package Included:
1x Happymodel BeecoreX FR F4 1S Flight Controller
1x Cable with Conenctor
1x Conenction Cable
4x Anti-Vibration Standoff
1x bag of Screws
