The Pixhawk® 4 Mini autopilot is designed for engineers and hobbyists who are looking to tap into the power of Pixhawk 4 but are working with smaller drones.
Pixhawk 4 Mini takes the FMU processor and memory resources from the Pixhawk 4 while eliminating interfaces that are normally unused. This allows the
Pixhawk 4 Mini to be small enough to fit in a 250mm racer drone.
Pixhawk 4 Mini was designed and developed in collaboration with Holybro® and Auterion®. It is based on the Pixhawk FMUv5 design standard and is optimized
to run PX4 flight control software.
Operating temperature: -40 ~ 85°c
Main FMU Processor: STM32F765, 32 Bit Arm® Cortex®-M7, 216MHz, 2MB memory, 512KB RAM
-8 PWM outputs
-4 dedicated PWM/Capture inputs on FMU
-Dedicated R/C input for CPPM
-Dedicated R/C input for Spektrum / DSM and S.Bus with analog / PWM RSSI input
-3 general purpose serial ports
-2 I2C ports
-3 SPI buses
-1 CANBuses for CAN ESC
-Analog inputs for voltage / current of battery
-2 additional analog input
Power Brick Input: 4.75~5.5V
USB Power Input: 4.75~5.25V
Servo Rail Input: 0~24V
Max current sensing: 120A
PM06 power management board:
Manual of pixhawk 4 mini, please click here.
1x Pixhawk 4 Mini flight controller
1x PM06 power management board
1x cable sets
Holybro Pixhawk 4 Mini Autopilot Flight Controller W/ PM06 Power Management 5V Output for RC Drone
Please allow 7 - 12 business days days for your order to arrive. We source products from all over the world to bring you epic offers and the lowest prices. This means sometimes you have to wait a little longer to get your order but it's always worth it!
Our policy lasts 14 days. If 14 days have gone by since your purchase, unfortunately we can't offer you a refund or exchange. To be eligible for a return, your item must be unused and in the same condition that you received it. It must also be in the original packaging.