iFlight TITAN DC2 122mm SucceX-A F4 40A 4S FPV Racing Drone PNP BNF w/ DJI Digital Air Unit FPV System
Brand Name: iFlight
Model: TITAN DC2 HD
Item Name: 122mm SucceX-A F4 40A 4S FPV Racing Drone
| SucceX-A F4 Flight Controller AIO 40A ESC | Brand Name: iFlight Model: SucceX-A Item Name: F4 OSD FC AIO 40A 4in1 ESC Input Voltage: recommended 2-6S
MCU: 168MHz STM32F405
Gyroscope: MPU6000
Blackbox: 8MB
OSD Chip: NO (Analog OSD not available)
OSD Betaflight: YES (Digital DJI Air Unit pass-through)
BEC: 5V 2.5A (3A MAX) / 10V 2.5A (3A MAX)
Voltage sensor scale: 110
Current sensor scale: 100
Inverter for SBUS input (UART2-RX)
Beeper pad: Yes
RSSI input pad: No
UARTs: 5
Motor outputs: 4
8 pin for DJI air unit port (10V, GNd, T1, R1, GND, R2I, T2, 5V)
BLHeli32 Telemetry:RX4
Target: STM32F405 (CLI config necessary; Check SETUP GUIDE above)
Mounting pattern: 30.5*30.5mm φ4mm with Grommets φ3mm
Dimensions: 40.5*43mm
Weight: 11.4g
USB type-C
Firmware: IFLIGHT_F405_AIO
|
| Onboard 40A BLHeli_32 4in1 ESC | Con. Current: 40A Burst Current: 50A
MCU: STM32F051
Up tp 48kHz PWM frequency
Capacitance: 484uF
Current Sensor: Yes
Input: 2-6S LIPO
BlHeli_32 telemetry: Yes
BEC: No
Supports up to Dshot1200, Proshot, Oneshot, Multishot
Target: iFlight-BL32-4IN1
Mounting pattern: 30.5*30.5mm/Φ3mm
Dimensions: 43*39mm (including the power pads)
|
| XING Nano 1404 4600KV Motor | Brand Name: iFlight Model: XING NANO 1404 Item Name: 1404 4600KV 3-4S Brushless Motor Configuration: 9N12P Stator Diameter: 14mm Stator Length: 4mm Shaft Diameter: 1.5mm No. of Cells: 3-4S Lipo Max. Current: 12.08A Size: 19.2x18.5mm Weight:9.3g |
| 2.3 Inch & 2.5 Inch Propeller | - Avan 2327 2.3 Inch 3-Blade Propeller ( 2 CW & 2 CCW) - 2540 2.5 Inch 3-Blade Propeller ( 2 CW & 2 CCW) - |
| FPV Transmitter & FPV Camera | DJI Digital HD Air Unit FPV System |
| Recommend Lipo Battery ( NOT Included) | Recommend 4S 650mAh 95C Lipo XT30 Plug(Outdoor) |
Pacakge Included:
1x iFlight DC2 HD 120mm FPV Racing Drone
1x Battery Strap
| Receiver |
FrSky R-XSR Receiver, Frsky XM+ Receiver, TBS NANO SE Receiver, Without Receiver compatible with DJI, Without receiver |
|---|
Please allow 7 - 15 business days for your order to arrive. We source products from all over the world to bring you epic offers and the lowest prices. This means sometimes you have to wait a little longer to get your order but it's always worth it!
for more information please visit our Shipping Policy page.
Our policy lasts 30 days. If 30 days have gone by since your purchase, unfortunately we can't offer you a refund or exchange. To be eligible for a return, your item must be unused and in the same condition that you received it. It must also be in the original packaging.
for more information please visit our Refund Policy page.